Page 73 - Vehicle Products Catalogue EN 012019

STANDARD TECHNICAL OPTIONAL
SPECIFICATIONS
1. Extension of the rigid fence at the end of arm - upper part
Electrical power supply Single-phase 230 VAC - 50/60Hz + ground. 2. Extension of the rigid fence at the end of arm - lower part
(not to be connected to an isolated ground 3. Automatic opening of the arm during power cuts
network or a high impedance earthed industrial 4. Locking of the arm in opened and/or closed position. The
network)
reaction in case of power cut (locked or not) must be specified
Consumption 450W when ordering
5. Double limit switches for information on BL status in the
Motor Three-phased asynchronous 250W. event of power failure
6. Tip support: fixed height tip, adjustable tip, electro-magnetic
Reversible ring and pinion speed reducer, service factor 1.2. tip, anti-vandalism tip, anti-vandalism + electro-magnetic tip
and electrically lockable tip
Useful arm length (L) 4 or 5m, resulting in free passage (PL) of 3.35 7. Hood and door intrusion information (by dry contact)
or 4.35m respectively. 8. Push-button box
9. Fireman emergency opening - anti-vandalism
Ambient operating Between -20 and +50°C. (Without optional 10. Programmable clock (weekly or yearly)
temperature heating) 11. Lockable switch on housing
12. Radio transmitter/receiver
Tolerated relative 95% without condensation. 13. Detection loop
humidity 14. Presence detector for inductive loops
15. Photoelectric cell for opening, closing or automatically
Minimum opening/ 6s (adjustable through the control board).
closing time stopping the barrier arm
16. Cell support post
Net weight (without arm) 300kg 17. Fixating of the cell
18. Electronic board for input/output CAN
MCBF (Mean Cycle In compliance with recommended 19. Totaling counter with reset button
Between Failure) maintenance: 3,000,000 cycles. 20. Leds on arm
21. Traffic lights (Leds) - alone or fixed on barrier
Noise emitted during <70db(A) (measured at 1m from the surface of 22. Support post for traffic lights
operation the machinery and at a height of 1.60m above 23. AS1049 card for third-party traffic signs
the ground; according to ISO3744. No hearing 24. Acoustic alarm 100 dB (±5) - fixed inside
protection needed.) 25. Aluminium STOP sign with a diameter of 300mm
26. LED flashing light on cover for arm movement signalisation
IP 44 27. Anti-vandalism belt, preventing the opening of doors and

EC compliant. hood
28. Paint of another RAL colour
SURFACE TREATMENTS 29. Treatment for aggressive saline environment. (recommended

77Zinc-coated internal mechanical parts when the barrier is installed within 10km of the coast and may be
77Complete body (housing, base plate, cover and doors): zinc subject to salt attack): sandblasting + Alu Zinc plating 80μm outside
(40μm inside) + polyzinc 80μm + 80μm powder paint
dusting + epoxy structured paint 30. Raised base
77Total thickness of the surface treatment exceeds 160 μm 31. 120 VAC - 60 Hz power supply
32. Thermostatic 250 or 500W heating for operation to -25 or
WORK TO BE SUPPLIED -45°C
BY THE CUSTOMER
Note : for restrictions on the options, consult the rate table.
77Ground installation
77Power supply
77Wiring to any external devices

Note: comply with the installation plan (CH6943).

With a constant view of adopting the latest technological developments, Automatic Systems reserves the right to amend the information above, at any time.

73 | Products Catalogue | Vehicle